*CREEP STRAIN RATE CONTROL

Control loadings based on the maximum equivalent creep strain rate.

This option is used to control loading based on a maximum equivalent creep strain rate calculated in a specified element set.

Related Topics
In Other Guides
Rate-dependent plasticity: creep and swelling

ProductsAbaqus/Standard

TypeHistory data

LevelStep

Required parameters

AMPLITUDE

Set this parameter equal to the AMPLITUDE name (of type DEFINITION=SOLUTION DEPENDENT) that is referenced by the loads being controlled (Amplitude Curves).

ELSET

Set this parameter equal to the name of the element set in which the search for the maximum equivalent creep strain rate is made. The CREEP option must be part of the MATERIAL definition (Material data definition) for some elements in the set.

Optional parameters

DEPENDENCIES

Set this parameter equal to the number of field variable dependencies included in the definition of the target creep strain rate, in addition to temperature and creep strain. If this parameter is omitted, it is assumed that the target creep strain rate depends only on the equivalent creep strain and, possibly, on temperature. The creep strain dependency curve at each temperature must always start at zero equivalent creep strain. See Material data definition for more information.

OP

Set OP=MOD (default) for existing target CREEP STRAIN RATE CONTROL definitions to remain, with this option defining target creep strain rates to be added or modified.

Set OP=NEW if all target creep strain rates defined in the previous step should be removed.

Data lines to define load control parameters

First line
  1. Target equivalent creep strain rate.

  2. Equivalent creep strain.

  3. Temperature.

  4. First field variable.

  5. Second field variable.

  6. Etc., up to five field variables.

Subsequent lines (only needed if the DEPENDENCIES parameter has a value greater than five)
  1. Sixth field variable.

  2. Etc., up to eight field variables per line.

Repeat this set of data lines as often as necessary to define the dependence of target strain rate on creep strain, temperature, and other predefined field variables.