ConstrainedSketchOptions object

Optional arguments

sheetSize

A Float specifying the sheet size. Possible values are Floats $>$ 0. The default value is the sheetSize specified with the Sketch method.

gridSpacing

A Float specifying the spacing between gridlines. Possible values are Floats $>$ 0. The default value is approximately 2.5% of sheetSize.

grid

A Boolean specifying whether the grid is shown. The default value is ON.

gridFrequency

An Int specifying how often gridlines are shown. Possible values are gridFrequency  $>$ 0. The default value is 1.

dimensionTextHeight

A Float specifying the height of the dimension text in points. Possible values are Floats $>$ 0. The default value is 12.0.

decimalPlaces

An Int specifying how many decimal places are shown in dimensions. Possible values are 0 $\le$  decimalPlaces  $\le$ 6. The initial value depends on the value of sheetSize.

constructionGeometry

A Boolean specifying whether construction geometry is shown. The default value is ON.

gridSnap

A Boolean specifying whether the cursor snaps to the grid. The default value is ON.

preselection

A Boolean specifying whether geometry will be preselected. The default value is ON.

sheetAuto

A Boolean specifying if the sheet size and the grid spacing are automatically computed. The default value is ON.

gridOrigin

A sequence of Floats specifying the X–Y coordinates for the origin of the grid. The default value is (0, 0).

gridAngle

A Float specifying the angle of the grid relative to the computer screen. The default value is 0.0.

viewStyle

A SymbolicConstant specifying the type of sketch displayed in the viewport. Possible values are REGULAR and AXISYM. The default value is REGULAR.

addImpliedConstraints

A Boolean specifying if implied constraints are added during sketching. The default value is ON.

maxCoplanarEntities

An Int specifying the maximum number of coplanar entities which should be automatically projected from the background, when a sketch based feature is created or edited. When this value is exceeded no entities are automatically projected and a warning issued. Possible values are maxCoplanarEntities  $>$ 0. The default value is 300.

autoConstrainAngularTolerance

A Float specifying the angular tolerance in degrees which is used to determine parallel and tangential conditions during the auto-constrain operation. For example any two lines which have an angle smaller than the given autoConstrainAngularTolerance will be assumed to be parallel, and a parallel constrain may be added during the auto-constrain operation. The default value is 0.01.

autoConstrainLinearTolerance

A Float specifying the linear tolerance which is used to determine when two points or geometries are coincident during the auto-constrain operation. The default value is 10^–6.

autoConstrainOptions

A sequence of SymbolicConstants specifying which type of constraints may be added by the auto-constraint tool. Possible values are PARALLEL, PERPENDICULAR, IDENTICAL, TANGENT, CONCENTRIC, and EQUALRADIUS. The default value is (PARALLEL,, PERPENDICULAR,, IDENTICAL,, TANGENT,, CONCENTRIC,, EQUALRADIUS).

dragMethod

A SymbolicConstant specifying the constraint solving mode used by the sketcher during drag operation. Possible values are MINIMUM_MOVE, STANDARD, WEIGHTED, and RELAXATION. The default value is MINIMUM_MOVE.

editMethod

A SymbolicConstant specifying the constraint solving mode used by the sketcher during regular sketch editing and adding new constraints and dimensions. Possible values are MINIMUM_MOVE, STANDARD, WEIGHTED, and RELAXATION. The default value is STANDARD.