Viewing the History of a Component Run

You can view the history of a run in the form of a table of components and runs in the Runtime Gateway. Each parameter has its own column, and each row denotes a run for the component.

  1. From the Runtime Gateway, select the component using the model explorer.

  2. Select the History tab.

    In the following example the ApproxLoop component from the ApproxLoop-AirplaneSizing example is displayed:



    The first column indicates the status of the run using the following symbols:

    The run was successful.


    The run was not successful.


    An approximation was executed instead of the actual component.



    Data were replaced by data from the database using either Database Lookup or Job Rerun. This symbol appears in the column beneath the icon indicating a successful or unsuccessful run. By default, the Database Lookup feature is disabled (see Setting Local Database Options).

    The next columns (before the parameter values) show the run for each component. The components are shown in relation to one another. The root is always run once. If process components are nested, the run numbers for components in the subflow of the lower-level process components cycle from 1 to N numerous times.

  3. If desired, click the at the bottom of the tab to toggle off and on the run grading and minimum/maximum bars. The bars indicate the magnitude of the cell's value relative to the range of all values in the column.

    By default, the minimum/maximum bars appear. To turn off the preference, see Setting Execution Preferences. For information about run grading, see Understanding Run Grading.

  4. If desired, you can view Tables Only, Tables and Graphs, or Graphs Only using the list at the bottom right of the tab. The figure above shows tables and graphs.

  5. If desired, select another component.